In the pictures from bottom to top, You can see the blueprint on the 3rd ring
and where you will need to scribe and cut the ring.
The next picture shows the ring after the cuts have been made and this leaves
you with 3 usable parts. The ring we are using now is the large ring for the rear of the droid.
Here again you work your way around the ring making sure everything lines up.
We also glued 2 Door Verticals at the front part of the ring.
These add support for the 2 large doors on the droid and you can see it also
adds support for the next ring plate.
No comments:
Post a Comment